TOHATSU TLDI MD 115A SERIES Service Manual page 221

Tighten shaft 2 until drive shaft 9 starts to move (rotate).
4.
When drive shaft starts to move, additionally tighten shaft
2 1/2 of a turn (180˚).
Tighten the nut to secure the plate so that the shaft 2 will
not move even if drive shaft is turned.
· As an alternative to the above measuring tool,
a tool used for pulling out the following
propeller shaft housing can be used to secure
forward gear (A) gear.
· When performing the work, assemble propeller
shaft ass'y and housing ass'y and bolts to
tighten to specified torque.
Propeller Shaft Housing Bolt q :
25 N · m (18 lb · ft) [2.5 kgf · m]
Propeller Shaft Housing Puller 0 :
P/N. 353-72252-0
Tightening Torque for Inspection a :
Tighten bolt gradually until propeller shaft
stops to turn.
TLDI 115A 2007
9
2
q
0
6
a
6-43