Reverse (C) Gears And Shim Selection - TOHATSU TLDI MD 115A SERIES Service Manual

35) Measurement of Back Lash
between Pinion (B) and Reverse (C)
Gears and Shim Selection
Before measuring backlash between pinion
(B) and reverse (C) gears, establish pinion
(B) gear height.
Refer to "Measurement of Pinion (B) Gear
Height and Shim Selection" in Chapter 6.
1. In accordance with procedure described in "Assembling
Lower Unit" in Chapter 6, install parts up to pump case
(lower).
Attach dial gauge plate 1 and secure it using bolt (M8,
2.
L=35mm) 2 and flat washer 2.
Attach backlash measuring tool kit parts 3 to 8 to
3.
propeller shaft housing ass'y 9, put the assembly in the
gear case, and secure it using bolt (M8, L=30mm) 0 and
flat washer 0.
Backlash Measuring Tool Kit
P/N. 3B7-72255-0
Nut M12-P1.5 3
P/N. 3B7-72735-0
Washer 13-21-2.5 4
P/N. 3B7-72707-0
Backlash Measuring Tool Plate 5
P/N. 3B7-72725-0
Backlash Measuring Tool Shaft 6
P/N. 3B7-72726-0
Measuring Tool Set Piece 7
3B7-72727-0
Measuring Tool Retainer 8
3B7-72903-0
TLDI 115A 2007
CAUTION
2
1
0
9
7
8
5
3
6
6
4
6-45