Disassembly Of Drive Shaft; Inspection Of Drive Shaft - TOHATSU MFS 25D Service Manual

24) Disassembly of Drive Shaft

Remove the shim 1 and outer race 2 .
1.
Remove the drive shaft spring 3.
2.
Use the universal puller plate 4 to remove the taper roller
3.
bearing 5 with a press.
Do not reuse the removed bearing.
Be sure to replace it with a new one.
• Check the bearing for play or deflection before
removal, and replace if necessary.
• When applying the universal puller plate to the
bearing, hook the tip of the puller claw onto the
inner race of the bearing correctly.
Universal Puller Plate 4:
P/N. 3AC-99750-0

25) Inspection of Drive Shaft

1. Check the drive shaft for bends and wear.
Replace if necessary.
2. Measure the drive shaft runout.
Runout Limit:
0.5 mm (0.020 in)
4st 25/30 2022
CAUTION
5 Taper Roller Bearing
Do not reuse.
5 Taper Roller Bearing
Do not reuse.
a Support Points
6
6-27