Check Of Safety Switch - AGFA DRYSTAR AXYS Service Manual

DD+DIS032.07E
4.2

Check of Safety Switch

(1) Switch on the printer. Wait till it shows
the READY screen (takes approx. 7
minutes)
(2) Open top cover
(3) Check display message: It must show
"Close top cover"
4.3 SW Patch Installation
(1) Install the latest SW patch, in case a recommended SW patch for the printer is
available. Refer to chapter 3.8, Software Releases, Patches.
4.4 Film Calibration
(1) Select in key-operator menu
'6 Calibration - 1 Film Calibration'
(2) Follow the instructions on the
display.
(3) Repeat film calibration for second
input tray
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
09-2007
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367
Maintenance
536609fa.cdr
Figure 18
536336as.cdr
Figure 19
Chapter 9 / 21
Agfa Company Confidential