Check Of Safety Switches - AGFA DRYSTAR 5302 Technical Documentation Manual

DD+DIS149.05E
Maintenance points - Power on
Check of safety
switche
SW patch installation
Film calibration
Density Reproduction
Check
Test image evaluation
Host system image
quality check
Completion
Backup
Reset of Maintenance
action counters and
relative infocounter
Customer conversation • Explanation of results of preventive maintenance.
The reader should always refer to MedNet to ensure that they are working with the latest copy of the document.
Edition 1, Revision 0
2005-09-09
• Opening of top cover to check function of safety
switche
• Installation of SW patch, in case a recommended
SW patch for the printer is available
• Calibration of the films in both input trays.
• Density Reproduction Check to confirm proper
operating CDM. Execution of CDM calibration if
not okay.
•
Printing of STI1, STI2 and medical test image
•
Comparison with test images made during printer
diagnostics
•
Check for artifacts on the film. In case of artifacts
in STI1 / STI2 and medical test image
troubleshooting as described in chapter 3.3
Troubleshooting.
•
Printing of diagnostic image from every host
system
•
Check concerning artifacts in diagnostic image.
Comparison with artifacts in last STI1 /STI2
image.
o In case artifacts are also visible in STI1 / STI2
image, troubleshooting as described in chapter
3.3 Troubleshooting.
o In case artifact is only visible in images of a
specific host but not in STI1 / STI2 image,
initiation of service call of modality service
engineer
• Backup of machine specific parameters
• Reset of Maintenance action counters
• Reset of relative infocounter
• Confirmation of the maintenance in the printer
service menu.
Printed copies of this document are not controlled.
DRYSTAR 5302
(Type 5366/100)
Maintenance Checklist
OK
OK
Maintenence Checklist Page 3 / 4
Agfa Company Confidential
not
OK
not
OK