AGFA DRYSTAR AXYS Service Manual page 406

DD+DIS032.07E
Check and
Cleaning of Drum
Cleaning of
Thermal print
head
Electrical check
Maintenance points - Power on
Smart Profile
Calibration
Check of safety
switch
SW patch
installation
Film calibration
Density
Reproduction
Check
Test image
evaluation
Host system
image quality
check
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
09-2007
• Check of the rubber of the drum for damage.
• Cleaning of the rubber of the drum with a lint free
cloth lightly moistened with Isopropyl alcohol or
Ethanol.
• Cleaning of the Thermal print head with a lint free
cloth lightly moistened with Isopropyl alcohol
• Check of the protective earth resistance
• Performing smart profile calibration, if print stripes
are visible in the 10" film edge area
• Opening of top cover to check function of safety
switch
• Installation of SW patch, in case a recommended
SW patch for the printer is available
• Calibration of the films in both input trays.
• Density Reproduction Check to confirm proper
operating CDM. Execution of CDM calibration if
not okay.
•
Printing of STI1, STI2 and medical test image
•
Comparison with test images made during printer
diagnostics
•
Check for artifacts on the film. In case of artifacts
in STI1 / STI2 and medical test image
troubleshooting as described in chapter 3.3
Troubleshooting.
•
Printing of diagnostic image from every host
system
•
Check concerning artifacts in diagnostic image.
Comparison with artifacts in last STI1 /STI2
image.
o In case artifacts are also visible in STI1 / STI2
image, troubleshooting as described in chapter
3.3 Troubleshooting.
o In case artifact is only visible in images of a
specific host but not in STI1 / STI2 image,
initiation of service call of modality service
engineer
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367
Maintenance
Maintenance Checklist
Agfa Company Confidential
DONE
Chapter 9 / 2