Download Print this page

Emergency Sw Installation On A Printer In "Error - System Failure" State - AGFA DRYSTAR AXYS Service Manual

Type 5367/100
Hide thumbs

Advertisement

Table of Contents
DD+DIS033.07E
4.3

Emergency SW Installation on a printer in "Error - System Failure" state

This chapter describes the SW Installation on a printer in ERROR - SYSTEM
Purpose
FAILURE state.
IMPORTANT:
The software installation procedure
described here formats the hard disk.
In case you select "NO" at question
"Do you want to preserve config" the
configuration data are erased.
In this case the printer is only in the
same state than before, if an up-to-
date backup is available.
In case the CF card is lost or not
readable the complete printer setup
has to be redone.
(1)
Insert the CF card with the printer
SW
Installation
"Emergency_Install" software in
on empty HD
the CF card reader
(2)
Reboot the printer
(3)
At question "Do you want to
preserve config?" select
"NO" in case you want to erase
the complete configuration
"YES" in case want to keep the
current configuration. Refer to
Figure 59 and to info below.
(4)
Follow the further instructions on
the local keypad.
(5)
Select menu "5 Restore
Configuration" to reload the
previous configuration when
finished.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
10-2007
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367/100
Repair and Service
Tools and Auxiliary Means
Emergency SW FOUND
ON EXTERNAL CF-card
Install emergency
SW?
YES (V)
NO (X)
Emergency SW Install
Do you want
to preserve config?
YES (V)
NO (X)
536632gc.cdr
Figure 59
2
Figure 60
Agfa Company Confidential
5366_Reg01_017_e.cdr
Chapter 3.2 / 59

Advertisement

Table of Contents
loading

  Also See for AGFA DRYSTAR AXYS