AGFA DRYSTAR AXYS Service Manual page 164

DD+DIS033 .07E
IMPORTANT:
After software installation on a new,
empty harddisk, the printer is only in
the same state than before, if an up-
to-date backup is available.
In case the CF card is lost or not
readable the complete printer setup
has to be redone.
After Emergency SW Installation on a
new, empty hard disk without
"Configuration Restore" the printer is
in the same state like it has been
shipped from factory
(default IP address 169.254.10.10)
NOTE:
The printer "Emergency_Install" software can be obtained via MEDNET, GSO Library.
Caution:
•
Depending on the software patch version it might be possible, that one of the
boards gets re-programmed during the software upgrade.
•
In case this re-programming is interrupted by power loss, this specific board may
become unusable.
•
Do not reboot the printer before requested by a local keypad message
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
10-2007
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367/100
Repair and Service
Tools and Auxiliary Mean
Emergency SW FOUND
ON EXTERNAL CF-card
Install emergency
SW? YES (V) NO (X)
Emergency SW Install
Do you want
to preserve config?
YES (V) NO (X)
536632gc.cdr
Figure 58
Agfa Company Confidential
s
Chapter 3.2 / 58