Calibrations - AGFA DRYSTAR AXYS Service Manual

DD+DIS033.07E
2

Calibrations

Following calibrations have to be performed at the printer:
Adjustment
Film calibration
Internal densitometer
(CDM) calibration
Print Head (TH)
calibration
Smart Profile
Calibration
Compliance Film
Calibration
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
06-2008
To be done ....
•
During maintenance.
•
After replacement of the Thermal
print head (TPH).
•
During the troubleshooting
procedure.
•
When the density reproduction
check indicates to calibrate the
CDM.
•
During the troubleshooting
procedure.
•
During the troubleshooting
procedure.
•
During the TH cleaning procedure.
Refer to section 3.2 in this chapter.
•
During the troubleshooting
procedure.
•
In certain cases during
maintenance. Refer to section 9,
Maintenance.
•
May be required as last step of an
Afssaps / EUREF calibration
procedure for a Drystar AXYS
Mammo printer.
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367/100
Repair and Service
Adjustments and Calibrations
Details see....
Agfa Company Confidential
2.1
2.2
2.3
2.4
2.5
Chapter 3.6 / 7