Performing A Compliance Film Calibration - AGFA DRYSTAR AXYS Service Manual
Type 5367/100
Hide thumbs
Also See for DRYSTAR AXYS:
- User manual (168 pages) ,
- Reference manual (137 pages) ,
- Manual (55 pages)
Table of Contents
Advertisement
DD+DIS033.07E
2.5.7
Performing a Compliance Film Calibration
NOTE:
Performing this step is only required, if the column "Deviation compared to DICOM
(%)" for one (or more) value(s) is ≥ 10 %. Refer to section 2.5.6.
With this calibration the printer applies a correction on the current film calibration using
the DT2M film.
(1)
Re-connect the printer to the service PC via network cable.
(2)
In the service command session select "6 Calibration – 6 Compliance film
calibration. The wizard as shown in Figure 18 will start.
(3)
Select "3 Proceed without resetting"
(4)
Select "proceed" (the described steps you performed already – neglect the
instructions in this screen)
(5)
Select the tray with DT2 Mammo films. If both trays keep DT2 Mammo films of
different format, perform the compliance film calibration for one tray, and repeat
it for the other tray
(6)
Select the configured densitometer. Refer to section 2.5.1
(7)
Select "Start calibration".
(8)
Enter Dmin and Dmax measured during step "2.5.6 Performing the Afssaps /
EUREF Calibration Check"
(9)
Leave "Reflected ambient light" and "View Box Illumination" values on default.
(10) Select for number of steps: "18 (EUREF)"
(11) Select "Start calibration".
(12) Enter the values measured in step "2.5.6 Performing the Afssaps / EUREF
Calibration Check"
7
2
*
to
IMPORTANT:
The browser screen where the 18 data are entered refreshes in a time interval of
1 minute. If you are not finished with entering all data within 1 minute, all entered
values will be reset to default values.
Workaround to avoid entering all data again: Press the "back button" in the browser.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
06-2008
4
.
7
. See IMPORTANT note below.
see Figure 18 page 31.
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Adjustments and Calibrations
2
*.
3
.
6
.
Type 5367/100
Repair and Service
5
.
Chapter 3.6 / 29
Agfa Company Confidential
Advertisement
Chapters
Table of Contents
