Chapter 5: PoE configuration using the
This chapter describes how to configure PoE on the Ethernet Routing Switch 8348TX-PWR or 8348GTX-
PWR module by using the Device Manager (DM).
Device Manager is a Simple Network Management Protocol (SNMP)-based graphical user interface (GUI)
tool that you use to manage single devices. To use Device Manager, you must have network connectivity
to a management station that runs Device Manager in one of the supported environments.
If 8348TX-PWR or 8348GTX-PWR modules are installed into an 86xx chassis, PoE is disabled and cannot
be enabled.
Caution:
Risk of equipment failure
Do not install Ethernet Routing Switch 8300 modules within the same chassis. Ethernet Routing Switch
8300 Series software does not support mixed configurations. A mixed configuration can damage the
modules and void your warranty.
Navigation
•
Displaying the PoE power supply information
•
Displaying PoE power availability and allocation
•
Configuring the PoE card
•
Configuring the PoE port
Select a topic:
•
Displaying the PoE power supply information
•
Displaying PoE power availability and allocation
•
Configuring the PoE card
•
Configuring the PoE port
Displaying the PoE power supply information
Display information about the PoE power supply.
Configuration — Power over Ethernet
Device Manager
on page 33
on page 34
on page 33
on page 34
on page 31
on page 32
on page 31
on page 32
May 2011
31