Set Ip Parameters Using Bootp; Setting Ip Parameters Using The Web-Based Management Interface - Avaya 4826GTS Installing Manual

Installing the Avaya Ethernet Routing Switch

Set IP parameters using bootp

The switch is configured to obtain a management IP address using BOOTP by default
If the switch is connected to the network and an appropriate bootp server is configured, then the
server assigns an IP address to the switch.
To view the assigned and in-use IP addresses, connect to the switch console and enter the show
ip command.

Setting IP parameters using the Web-based Management Interface

Prerequisite
Ensure that the switch has an IP address.
Procedure
To set IP parameters using the Web-based Management Interface, perform the following procedure.
1. Connect a computer to the switch through a data port using a standard RJ-45 network cable.
2. Open a Web browser on the attached computer and enter the management IP address and
press Enter. For example, 192.168.1.1. The switch summary screen appears on your
browser.
3. From the navigation tree, double-click Administration.
4. In the Administration tree, double-click Quick Start. The IP/Community/Vlan
5. In the IP/Community/Vlan work area, type a switch or stack IP address in the In-Band Stack
IP Address dialog box.
6. In the In-Band Stack Subnet Mask dialog box, type a subnet mask.
7. In the Default Gateway dialog box, type an IP address.
8. In the Read-Only Community String box, type a character string.
9. In the Re-enter to verify dialog box immediately following the Read-Only Community String
box, retype the character string from Step 8.
10. In the Read-Write Community String dialog box, type a character string.
11. In the Re-enter to verify dialog box immediately following the Read-Write Community String
box, retype the character string from Step 10.
12. In the Quick Start VLAN dialog box, type a VLAN ID ranging from 1 to 4094.
13. Click Apply.
August 2016 Installing Avaya ERS 4800 Series
Comments on this document? infodev@avaya.com
34