Configuring Https Mode Using Edm - Avaya 8800 User Interface Fundamentals

Procedure steps
1. From the navigation menu, open Configuration, Security, Control Path
2. Click General.
3. Click the Web tab and enter a port number to use as the HTTP port.
4. Click Apply.

Configuring HTTPS mode using EDM

If you disable HTTPS mode and require secure connection to the switch over the Web, use
the following procedure to re-enable the Web server secure-only option. Only HTTPS
connections will be available. You can also use this procedure to allocate a port, other than
the default, for HTTPS use.
Important:
Avaya strongly recommends that you discover the ports that UDP and TCP are already using
before you select a port for HTTPS. Use the following commands to list the ports already in
use and then select a port that is not in the resulting list.
For the CLI, use: show ip tcp info-connections and show ip udp endpoints.
For the ACLI, use: show ip tcp connections.
As a general recommendation, you should avoid using the ports between 1024-1100. Use
ports 1100 and above.
Note:
When you change the default HTTPS port number while connected to EDM, you will lose
connectivity. You can then reconnect to the switch using the new port number.
Procedure steps
1. From the navigation menu, open Configuration, Security, Control Path
2. Click General.
3. Click the Web tab and select the SecureOnly option.
4. Enter a port number to use as the HTTPS port.
User Interface Fundamentals
Configuring HTTPS mode using EDM
July 2013 55