AAUR: configuration for the units in the stack is not saved
on the base unit
Use the recovery tree in this section if configuration for the units in the stack is not saved on
the base unit. The typical scenario is that configuration for a unit in a stack is not saved on the
base unit because the AUR Auto-Save is disabled. You can manually save the configuration
of a non–base unit to the base unit regardless of the state of the AUR feature.
Configuration for the units in the stack is not saved on the base unit
recovery tree
About this task
The following figure shows the recovery tree to save configuration for the units in the stack to
the base unit. Check that AUR is enabled. If AUR is not enabled, either save the configuration
manually or enable AUR.
Troubleshooting 5.1
AAUR: configuration for the units in the stack is not saved on the base unit
February 2013
45