Ntdp Timer Port-Delay - Huawei Quidway S2000 Series Command Manual

Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches
This command is executed on the collecting device. The topology request contains the
hop-delay time, according to which the collected device decides how long it shall wait
before the first port forwards the request.
Example
# Configure that the collected device receives NTDP request and delays for 300ms
before transmitting the NTDP packet to the first port.
[Quidway] ntdp timer hop-delay 300

1.2.8 ntdp timer port-delay

Syntax
ntdp timer port-delay time
undo ntdp timer port-delay
View
System view
Parameter
time: The delay before forwarding the topology request packet to the next port, ranging
from 1 to 100 in milliseconds. By default, the value is 20ms.
Description
Using ntdp timer port-delay command, you can configure the delay before the next
port's forwarding packets on the collected device. Using undo ntdp timer port-delay
command, you can restore the default port-delay.
To avoid network congestion resulted from collecting device's receiving large amount of
responses simultaneously, you can configure each collected device to delay response
for a period of time after receiving the topology request. Then, the first port will start to
forward the topology request packet.
This command is configured on the collecting device. The topology request contains
the port-delay time, according to which the collected device decides how long it shall
wait before the first port forwards the request.
Example
# Configure that the collected device shall delay for 40ms before the next port sends
the request.
Chapter 1 HGMP V2 Configuration Commands
1-14