Stp Root Primary - Huawei Quidway S2000 Series Command Manual

Command Manual - STP
Quidway S2000 Series Ethernet Switches
Parameter
bridge-priority: Specifies the priority of a switch, ranging from 0 to 61440. The values
are not consecutive integers. The step length is 4096. By default, the value is 32768.
Description
Using stp priority command, you can configure the bridge priority of the switch. Using
undo stp priority command, you can restore the default bridge priority of the switch.
The priority value shall be a multiple of 4096, such as 0, 4096, 8192 etc. The smaller
value represents the higher priority. A switch with higher priority is more likely to be a
root bridge.
Example
# Set the priority of the current Ethernet switch to 4096.
[Quidway] stp priority 4096

1.1.13 stp root primary

Syntax
stp root primary
undo stp root
View
System view
Parameter
none
Description
Using stp root primary command, you can configure the current switch as the
primary root of a spanning tree. Using undo stp root primary command, you can
cancel the current switch for primary root of a spanning tree.
By default, a switch is not a primary root.
You can designate a primary tree for the spanning tree without caring about the priority
configuration of the switch.
Chapter 1 RSTP Configuration Commands
1-10