Delete-Member - Huawei Quidway S2000 Series Command Manual

Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches
Authentication is also required when you switch from a member device to the
administrator device. After passing the authentication, the system will enter the user
view automatically.
When executed on the administrator device, if the specified member number n is
omitted, the error message will be on display. Enter quit to stop the switchover
operation.
Example
# Switch from the administrator device to member device 6 and then switches back to
the administrator device.
<Huawei_0.Quidway> cluster switch-to 6
<Huawei_6.Quidway> quit
<Huawei_0.Quidway>

1.3.8 delete-member

Syntax
delete-member member-num
View
Cluster view
Parameter
member-num: Number of a member device, ranging from 1 to 255.
Description
Using delete-member command, you can cancel a member from the cluster.
This command can be performed on administrator device. After performing this
command, the administrator device will notify a member device to exit cluster and
delete it from the member list. If the administrator device and the member device still
cannot intercommunicate, the member will be deleted, however, the cluster information
on the member device may not be deleted.
Example
# Delete the switch from cluster, its member number is 2.
[Huawei_0.Quidway-cluster] delete-member 2
Chapter 1 HGMP V2 Configuration Commands
1-21