Reset Stop-Accounting-Buffer - Huawei Quidway S2000 Series Command Manual

Command Manual - Security
Quidway S2000 Series Ethernet Switches
RADIUS protocol configuration is performed on a per-RADIUS-server-group basis.
Every RADIUS server group shall at least have the specified IP address and UDP port
number of the RADIUS authentication/authorization/accounting server and some
necessary parameters exchanged with the RADIUS client end (switch system). So it is
necessary to create the RADIUS server group and enter its view before performing
other RADIUS protocol configurations.
A RADIUS server group can be used by several ISP domains at the same time.
Although undo radius scheme can remove a specified RADIUS server group.
However, the default one cannot be removed. Note that a serer group currently in use
by the online user cannot be removed.
For the related commands, see key, retry realtime-accounting, radius-scheme,
timer
stop-accounting, server-type, state, user-name-format, retry , display radius,
display radius statistics .
Example
# Create a RADIUS server group named "huawei" and enters its view.
[Quidway] radius scheme huawei
[Quidway-radius-huawei]

2.2.11 reset stop-accounting-buffer

Syntax
reset stop-accounting-buffer { radius-scheme radius-scheme-name | session-id
session-id | time-range start-time stop-time | user-name user-name }
View
User view
Parameter
radius-scheme radius-server-name: Configures to delete the stopping accounting
requests from the buffer according to the specified RADIUS server name.
radius-server-name specifies the RADIUS server name with a character string not
exceeding 32 characters, excluding "/", ":", "*", "?", "<" and ">".
session-id session-id: Configures to delete the stopping accounting requests from the
buffer according to the specified session ID. session-id specifies the session ID with a
character string not exceeding 50 characters.
time-range start-time stop-time: Configures to delete the stopping accounting requests
from the buffer according to the saving time. Start-time specifies the start time of the
saving time range and stop-time specifies the stop time of the saving time range. The
realtime-accounting,
Chapter 2 AAA Configuration Commands
stop-accounting-buffer
2-24
enable, retry