Huawei Quidway S2000 Series Command Manual page 212

Command Manual - Security
Quidway S2000 Series Ethernet Switches
Parameter
radius-scheme radius-server-name: Configures to display the saved stopping
accounting requests according to RADIUS server name. radius-server-name specifies
the RADIUS server name with a character string not exceeding 32 characters,
excluding "/", ":", "*", "?", "<" and ">".
session-id session-id: Configures to display the saved stopping accounting requests
according to the session ID. session-id specifies the session ID with a character string
not exceeding 50 characters.
time-range start-time stop-time: Configures to display the saved stopping accounting
requests according to the saving time. start-time specifies the start time of the saving
time range and stop-time specifies the stop time of the saving time range. The time is
expressed in the format hh:mm:ss-yyyy/mm/dd. When this parameter is specified, all
the stopping accounting requests saved in the time range since start-time to stop-time
will be displayed.
user-name user-name : Configures to display the saved stopping accounting requests
according to the username. User-name specifies the username, a character string not
exceeding 32 characters, excluding "/", ":", "*", "?", "<" and ">". The @ character can
only be used once in one username. The pure username (the part before @, namely
the user ID) cannot exceed 24 characters.
Description
Using display stop-accounting-buffer command, you can view the stopping
accounting requests, which have not been responded and saved in the buffer.
After transmitting the stopping accounting requests, if there is no response from the
RADIUS server, the switch will save the packet in the buffer and retransmit it for several
times, which is set through the retry realtime-accounting command.
This command is used to display the stopping accounting requests saved in the switch
buffer. You can select to display the packets sent to a certain RADIUS server, or display
the packets according to user session ID or username. You may also display the
request packets saved during a specified time range. The displayed packet information
can help with diagnosis and troubleshooting.
For the
stop-accounting-buffer enable, retry stop-accounting.
Example
# Display the stopping accounting requests saved in the system buffer since 0:0:0 to
23:59:59 on August 31, 2002.
<Quidway>
23:59:59-2002/08/31
Total find
related commands,
display stop-accounting-buffer
0 record
2-19
Chapter 2 AAA Configuration Commands
see reset stop-accounting-buffer,
time-range 0:0:0-2002/08/31