Display Igmp-Snooping Group - Huawei Quidway S2000 Series Command Manual

Command Manual - Multicast
Quidway S2000 Series Ethernet Switches
The information above tells us that: IGMP Snooping is enabled; the router port timer
is set to be 300 seconds; the max response timer is set to be 50 seconds; the aging
timer of multicast group member is set to be 500 seconds.

2.1.2 display igmp-snooping group

Syntax
display igmp-snooping group [ vlan vlanid ]
View
Any view
Parameter
vlan vlanid: Specifies the VLAN where the multicast group to be viewed is located.
When the parameter is omitted, the command will display the information about all
the multicast groups on the VLAN.
Description
Using display igmp-snooping group command, you can view the IP multicast
groups and MAC multicast groups under VLAN.
This command displays the IP multicast group and MAC multicast group information
of a VLAN or all the VLAN where the Ethernet switch is located. It displays the
information such as VLAN ID, router port, IP multicast group address, member ports
in the IP multicast group, MAC multicast group, MAC multicast group address, and
the member ports in the MAC multicast group.
Example
# Display the multicast group information about VLAN2.
<Quidway> display igmp-snooping group vlan 2
***************Multicast group table***************
Vlan(id):2.
Router port(s):Ethernet0/1
IP group(s):the following ip group(s) match to one mac group.
IP group address:230.45.45.1
Member port(s):Ethernet0/12
MAC group(s):
MAC group address:01-00-5e-2d-2d-01
Member port(s):Ethernet0/12
Chapter 2 IGMP Snooping Configuration Commands
2-2