Info-Center Trapbuffer - Huawei Quidway S2000 Series Command Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches
Example
# Configure the debugging information timestamp format as boot.
[Quidway] info-center timestamp debugging boot

4.5.13 info-center trapbuffer

Syntax
info-center trapbuffer [ size buffersize ] [ channel { channel-number |
channel-name } ]
undo info-center trapbuffer [ channel | size ]
View
System view
Parameter
size: Configure the size of the trap buffer.
buffersize: Size of trap buffer (numbers of messages).
channel: Configure the channel to output information to trap buffer.
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.
channel-name: Specify the channel name.
Description
Using info-center trapbuffer command, you can output information to the trap buffer.
Using undo info-center trapbuffer command, you can cancel output information to
trap buffer.
By default, output information is transmitted to trap buffer and size of trap buffer is 20.
This command takes effect only after the system logging is enabled.
For the related commands, see info-center enable, display info-center.
Example
# Send information to the trap buffer and sets the size of buffer as 30.
[Quidway] info-center trapbuffer size 30
Chapter 4 System Maintenance Commands
4-33