Secondary Accounting - Huawei Quidway S2000 Series Command Manual

Command Manual - Security
Quidway S2000 Series Ethernet Switches
message from the switch to RADIUS accounting server has not been responded, the
switch shall save it in the local buffer and retransmit it until the server responds or
discard the messages after transmitting for specified times.
For the related commands, see reset stop-accounting-buffer , radius scheme,
display stop-accounting-buffer .
Example
# Indicate that, when stopping accounting request for the server "Huawei" in the
RADIUS server group, the switch system will retransmit the packets for up to 1000
times.
[Quidway-radius-huawei] retry stop-accounting 1000

2.2.15 secondary accounting

Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS server group view
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
second accounting server is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By default, the
accounting service is provided via UDP 1813.
Description
Using secondary accounting command, you can configure the IP address and port
number for the second RADIUS accounting server. Using undo secondary
accounting command, you can restore the IP address and port number to default
values.
For detailed information, read the Description of the primary accounting command.
For the related commands, see key, radius scheme, state.
Example
# Set the IP address of the second accounting server of RADIUS server group, huawei,
to 10.110.1.1 and the UDP port 1813 to provide RADIUS accounting service.
[Quidway-radius-huawei] secondary accounting 10.110.1.1 1813
Chapter 2 AAA Configuration Commands
2-28