Link-Aggregation - Huawei Quidway S2000 Series Command Manual

Command Manual - Port
Quidway S2000 Series Ethernet Switches
Table 2-1 The description of link aggregation
Master port
Other sub-ports
Mode

2.1.2 link-aggregation

Syntax
link-aggregation port_num1 to port_num2 { both | ingress }
undo link-aggregation { master_port_num | all }
View
System view
Parameter
port_num1: Starting range value of Ethernet port joined the Ethernet link aggregation.
port_num2: Last range value of Ethernet port joined the Ethernet link aggregation.
both: Configures that the sub-ports in the link aggregation share outgoing load on the
port depending on the source address and destination MAC address.
ingress: Configures that the sub-ports in the link aggregation share outgoing load on
the port depending on the source MAC addresses.
master_port_num: Master port number in link aggregation.
all: all aggregated ports.
Description
Using link-aggregation command, you can configure a series of ports to aggregation
port and the port with the smallest port number as master port. Using undo
link-aggregation command, you can cancel the Ethernet link aggregation.
Note that the Ethernet ports to be aggregated can not work in auto-negotiation mode
and must work in the same mode, which can be 10M_FULL (10Mbps speed, full
duplex) or 100M_FULL (100Mbps speed, full duplex), otherwise, they cannot be
aggregated.
For the related command, see display link-aggregation.
Example
# Configure outgoing load balance on the port depending on the source and
destination MAC addresses.
[Quidway] link-aggregation ethernet0/1 to ethernet0/2 both
Chapter 2 Ethernet Port Link Aggregation Commands
Field
Master port
Other member ports
Aggregation mode
2-2
Description