Stp - Huawei Quidway S2000 Series Command Manual

Command Manual - STP
Quidway S2000 Series Ethernet Switches
[ to { interface_type interface_num | interface_name } ] }&<1-10>. For details about
interface_type, interface_num and interface_name, refer to the Port Command
Manual. &<1-10> indicates the preceding parameter can be input up to 10 times.
Description
Using reset stp command, you can reset the statistics information about Rapid
Spanning Tree Protocol (RSTP).
This command can be used to clear the statistics information about a specified port. If
no port is specified, the statistics information of all the ports of the device will be
cleared.
For the related command, see display stp.
Example
# Clear the statistics information about Ethernet0/1 through Ethernet0/3.
<Quidway> reset stp interface ethernet0/1 to ethernet0/3

1.1.3 stp

Syntax
stp { enable | disable }
undo stp
View
System view/Ethernet port view
Parameter
enable: Enables RSTP on a device or a port.
disable: Disables RSTP on a device or a port.
Description
Using stp enable command, you can enable RSTP on a device or port. Using stp
disable command, you can disable RSTP on a device or port. Using undo stp
command, you can disable RSTP on a device.
By default, RSTP is not enabled on the Switch. However, after RSTP is enabled on the
device, it is enabled on all the ports by default.
If the parameters of RSTP have not been set for the device or the ports before RSTP
is enabled on the device, they will take the default values. Before or after RSTP is
enabled, you can use the configuration command to set RSTP parameters for the
device and ports. This command enables/disables RSTP on a device in system view
and enables/disables RSTP on a port in Ethernet port view.
Chapter 1 RSTP Configuration Commands
1-3