Display Ip Routing-Table Ip_Address1 Ip_Address2 - Huawei Quidway S2000 Series Command Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches
Field
State
Age
Cost

2.1.7 display ip routing-table ip_address1 ip_address2

Syntax
display ip routing-table ip_address1 mask1 ip_address2 mask2 [ verbose ]
View
Any view
Parameter
ip_address1, ip_address2: Destination IP address in dotted decimal notation.
ip_address1 and ip_address2 determine one address range together to display the
route in this address range.
mask1, mask2: IP address mask, length in dotted decimal notation or integer form. It
ranges from 0 to 32 when it is presented in integer.
Route state description:
ActiveU The route is selected and is optimum
Blackhole route is similar to Reject route, but it will not send the ICMP
Blackhole
unreachable message to the source end
Delete The route is deleted
Gateway Identifies that the route is not an interface route
The route exists, but it is unavailable temporarily for some reasons (e.g.,
Hidden configured policy or interface is Down). Moreover, you do not wish to delete it.
Therefore, you need to hide it, so as to restore it again later
Holddown is one kind of route redistribution policy adopted by some
distance-vector (D-V) routing protocols, through which these routing protocols
can avoid the flooding of error routes and deliver the routing unreachable
Holddown message accurately. For example, the RIP redistributes a certain route every a
period of time regardless of whether the actually found routes destined for the
same destination change. For more details, refer to the specific routing
protocols.
Int The route is discovered by interior gateway protocol (IGP).
The routing protocol does not redistribute NoAdvise route when it redistributes
NoAdvise
routes based on the policy.
The routing protocol generally selects the route with the highest precedence
from its routing table, then places it in its core routing table and redistributes it.
NotInstall
Although the NotInstall route cannot be placed in the core routing table, it is
possibly that it is selected and redistributed.
Unlike the normal routes, the Reject route will discard the packets that select it
Reject
as their route, and the router will send ICMP unreachable message to the
source end. Reject route is usually used for the network test
When the routes from the routing table are deleted, the routes with Retain flag
Retain will not be deleted. Using this function you can set Retain flag for some static
routes, so that they can exist in the core routing table.
The route with Static flag will not be cleared from the routing table after you
Static save it and reboot the router. Generally, the static route configured manually in
the router belongs to a Static route.
Unicast Unicast route
Time to live
Cost
2-8
Chapter 2 System IP Configuration Commands
Description