Garp Timer Leaveall - Huawei Quidway S2000 Series Command Manual

Command Manual - VLAN
Quidway S2000 Series Ethernet Switches
Parameter
hold: GARP Hold timer. After received certain registration information, the GARP
application entity will not send Join Message at once, instead, it starts the Hold timer.
All the registration information received within duration of the Hold timer will be
transmitted in the same frame after the Hold timer times out, thereby saving the
bandwidth resource.
join: GARP Join timer. GARP application entity will send out Join message after the
Join timer goes timeout to make other GARP application entity register its own
information.
leave: GARP Leave timer . When a GARP application entity wants to deregister
certain attribute information, it sends Leave message. The GARP application entity
received the message will starts Leave timer. If the entity receives no Join message
before the timer goes timeout, it will deregister the attribute information.
timer_value: Value of GARP hold timer, join timer and leave timer in centisecond. The
step is 5 centiseconds. The range is according to the following rule: the value of Join
timer should be no less than the doubled value of Hold timer, and the value of Leave
timer should be greater than the doubled value of Join timer and smaller than the
Leaveall timer value, and the minimal value of Join timer is 10 centiseconds. By
default, Hold timer is 10 centiseconds, Join timer is 20 centiseconds, Leave timer is 60
centiseconds.
Description
Using garp timer command, you can configure GARP timer value. Using undo garp
timer command, you can restore the default value of GARP timer.
For the related command, see display garp timer.
Example
# Set Join timer of GARP as 300ms.
[Quidway-Ethernet0/1] garp timer join 30

3.1.4 garp timer leaveall

Syntax
garp timer leaveall timer_value
undo garp timer leaveall
View
System view
Chapter 3 GARP/GVRP Configuration Commands
3-3