Timer Realtime-Accounting - Huawei Quidway S2000 Series Command Manual

Command Manual - Security
Quidway S2000 Series Ethernet Switches
After RADIUS (authentication/authorization or accounting) request packet has been
transmitted for a period of time, if NAS has not received the response from RADIUS
server, it has to retransmit the message to guarantee RADIUS service for the user. The
period taken is called RADIUS server response timeout time, which is controlled by the
RADIUS server response timeout timer in the switch system. This command is used to
set this timer.
Setting a suitable timer according to the network situation will enhance the system
performance.
For the related commands, see radius scheme, retry.
Example
# Set the response timeout timer of RADIUS server group, huawei, to 5 seconds.
[Quidway-radius-huawei] timer 5

2.2.21 timer realtime-accounting

Syntax
timer realtime-accounting minute
undo timer realtime-accounting
View
RADIUS server group view
Parameter
minute: Real-time accounting interval, ranging from 3 to 60 and measured in minutes.
By default, the value is 12. It must be a multiple of 3.
Description
Using timer realtime-accounting command, you can configure the real-time
accounting interval. Using undo timer realtime-accounting command, you can
restore the default interval.
To implement real-time accounting, it is necessary to set a real-time accounting interval.
After the attribute is set, NAS will transmit the accounting information of online users to
the RADIUS server regularly.
The value of minute is related to the performance of NAS and RADIUS server. The
smaller the value is, the higher the requirement for NAS and RADIUS server is. When
there are a large amount of users (more than 1000, inclusive), we suggest a larger
value. The following table recommends the ratio of minute value to number of users.
Chapter 2 AAA Configuration Commands
2-33