Display Ip Routing-Table Ip_Address - Huawei Quidway S2000 Series Command Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches
127.0.0.1/32
Table 2-4 Description of information generated by the command display ip routing-table
Destination/Mask
Proto
Pre
Cost
Nexthop
Interface

2.1.6 display ip routing-table ip_address

Syntax
display ip routing-table ip_address [ mask ] [ longer-match ] [ verbose ]
View
Any view
Parameter
ip_address: Destination IP address.
mask: IP address mask, length in dotted decimal notation or integer. It ranges from 0
to 32 when it is expressed with integer.
verbose: With the verbose parameter, this command displays the verbose
information of both the active and inactive routes. Without the parameter, this
command only displays the summary of active routes.
longer-match: Address route matching the destination address in natural mask range.
Description
Using display ip routing-table ip_address command, you can view the routing
information of the specified destination address.
With different parameters, the output of command is different. The following is the
output description for different forms of this command:
display ip routing-table ip_address
If destination address, ip_address, has corresponding route in natural mask range,
this command will display all subnet routes or only the route best matching the
destination address, ip_address, is displayed. And only the active matching route is
displayed.
display ip routing-table ip_address mask,
DIRECT 0
Field
Destination address/Mask length
Routing protocol
Routing preference
Cost
Next hop address
Output interface, through which the data packet destined for the destination
network segment is sent
Chapter 2 System IP Configuration Commands
0 127.0.0.1
Description
2-5
InLoopBack0