Dot1X Timer Handshake-Period - Huawei Quidway S2000 Series Command Manual

Command Manual - Security
Quidway S2000 Series Ethernet Switches
tx-period-value: Specify how long the duration of the transmission timeout timer is. The
value ranges from 10 to 120 in units of second and defaults to 30.
Description
Using dot1x timer command, you can configure the 802.1x timers. Using undo dot1x
timer command, you can restore the default values.
When it is run, 802.1x enables many timers to control the rational and orderly
interacting of the Supplicant, the Authenticator and the Authenticator Server. This
command can set some of the timers (while other timers cannot be set) to adapt the
interaction process. It could be necessary for some special and hard network
environment. Generally, the user should keep the default values of the timers.
For the related commands, see display dot1x.
Example
# Set the Authentication Server timeout timer is 150s.
[Quidway] dot1x timer server-timeout 150

1.1.12 dot1x timer handshake-period

Syntax
dot1x timer handshake-period interval
undo dot1x timer handshake-period
View
system view
Parameter
interval: Handshake period, range from 1 to 1024, unit in second.
Description
dot1x timer handshake-period is used to set the handshake period of 802.1x
dot1x timer handshake-period is used to restore the handshake period to default
value
.
By default, handshake period is 15s.
After setting handshake-period, system will send the handshake packet by the period
Suppose the dot1x retry time is configured as N, the system will consider the user
having logged off and set the user as logoff state if system doesn't receive the response
from user for consecutive N times.
Example
# Set the handshake period of 802.1x to 200 seconds.
Chapter 1 802.1x Configuration Commands
1-12
undo
.
.