Info-Center Loghost Source - Huawei Quidway S2000 Series Command Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8,
trapbuffer.
facility: Configure the recording tool of info-center loghost.
local-number: Record tool of info-center loghost, ranging from local0 to local7.
language: Set the logging language.
chinese,english: Language used in log file.
Description
Using info-center loghost command, you can configure the IP address of the
info-center loghost to send information to it. Using undo info-center loghost
command, you can cancel output to info-center loghost.
By default, Ethernet switches do not output information to info-center loghost.
This command takes effect only after the system logging is enabled.
For the related commands, see info-center enable,display info-center.
Example
# Configure to send log information to the UNIX workstation at 202.38.160.1.
[Quidway] info-center loghost 202.38.160.1

4.5.8 info-center loghost source

Syntax
info-center loghost source interface-name
undo info-center loghost source
View
System view
Parameter
source interface-name: set source address of the packets sent to loghost as the
address of the interface specified by the interface-name. Normally, the interface should
be VLAN interface.
channel9, console,
Chapter 4 System Maintenance Commands
logbuffer, loghost,
4-27
monitor, snmpagent,