Display Arp - Huawei Quidway S2000 Series Command Manual

Command Manual - Network Protocol
Quidway S2000 Series Ethernet Switches
Table 1-1 Output description of the debugging arp packet display
Field
operation
sender_eth_addr
sender_ip_addr
target_eth_addr
target_ip_addr

1.1.4 display arp

Syntax
display arp [ dynamic | static | ip-address ]
View
Any view
Parameter
dynamic: Display the dynamic ARP entries in ARP mapping table.
static: Display the static ARP entries in ARP mapping table.
ip-address: Display ARP mapping entries according to specified IP address.
Description
Using display arp command, you can view the ARP mapping table.
For the related command, see arp static, reset arp, debugging arp.
Example
# Display all the ARP entries.
<Quidway> display arp
IP Address
10.1.1.2
10.110.91.175
--- 2 entries found
Kind of ARP packets: 1 ARP request packet; 2 ARP reply packet
Ethernet address of the sender
IP address of the sender
Target Ethernet address. If the packet is ARP request packet, the target IP address will be 0
Target IP address
MAC Address
00e0-fc01-0102
0050-ba22-6fd7
---
1-4
Chapter 1 ARP Configuration Commands
Description
VLAN ID Port Name
N/A N/A
1 Ethernet0/1 20
Aging Type
N/A Static
Dynamic