Loopback-Detection Interval-Time - Huawei Quidway S2000 Series Command Manual

Command Manual - Port
Quidway S2000 Series Ethernet Switches
Description
Using loopback-detection enable command, you can enable the port loopback
detection. If there is a loopback port found, the switch will put it under control. Using
undo loopback-detection enable command, you can disable the port loopback
detection.
Using this command in the system, you can enable/disable the port loopback detection
function of the entire device; using this command in Ethernet port view, you can
enable/disable the port loopback detection function of the current port.
By default, port loopback detection is enabled.
For the related command, see display loopback-detection.
Example
# Enable the port loopback detection.
[Quidway] loopback-detection enable

1.1.14 loopback-detection interval-time

Syntax
loopback-detection interval-time time
undo loopback-detection interval-time
View
System view
Parameter
time: Specifies the interval of monitoring external loopback conditions of the port. It
ranges from 5 to 300, measured in seconds. By default, the interval is 30 seconds.
Description
Using loopback-detection interval-time command, you can configure detection
interval
loopback-detection interval-time command, you can restore the default interval.
For the related command, see display loopback-detection.
Example
# Configure the detection interval for the external loopback condition of each port to 10
seconds.
[Quidway] loopback-detection interval-time 10
for the external loopback
Chapter 1 Ethernet Port Configuration Commands
condition of
1-11
each port. Using undo