Set Authentication Password - Huawei Quidway S2000 Series Command Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches
Visit level: Commands of this level involve command of network diagnosis tool
(such as ping and tracert), command of switch between different language
environments of user interface (language-mode), and telnet command etc. The
operation of saving configuration file is not allowed on this level of commands.
Monitoring level: Commands of this level, including the display command and the
debugging command, are used for system maintenance, service fault diagnosis,
etc. The operation of saving the configuration file is not allowed on this level of
commands.
Configuration level: Service configuration commands, including routing command
and commands on each network layer, are used to provide direct network service
to the user.
Management level: These are commands that influence the basic operation of the
system and system support module, which plays a supporting role on service.
Commands of this level involve file system commands, FTP commands, TFTP
commands, XModem downloading commands, user management commands,
and level setting commands.
Example
# Configure the user zbr to use commands at level 0 after logon.
[Quidway] local-user zbr
[Quidway-luser-zbr] service-type telnet level 0
# Quit the system and logs on with username "zbr" again. Now only the commands at
level 0 are listed on the terminal.
[Quidway] quit
<Quidway> ?
User view commands:
language-mode
ping
quit
super
telnet
tracert

1.1.21 set authentication password

Syntax
set authentication password { cipher | simple } password
undo set authentication password
View
User interface view
Chapter 1 Logging in Ethernet Switch Commands
Specify the language environment
Ping function
Exit from current command view
Privilege specified user priority level
Establish one TELNET connection
Trace route function
1-15