Removal - Chrysler 2005 Crossfire SRT6 Service Manual

5 - 350 BRAKES - ABS SERVICE INFORMATION

REMOVAL

1. Clean off the top of the HCU, especially around the
hydraulic lines (1-6). Be sure there is not any
debris that could fall into the brake line holes.
Note: To aid in reassembly, insure the hydraulic
brake lines and corresponding connections at the
HCU are clearly marked before disassembly.
2. Remove the hydraulic lines from the HCU. Seal off
the hydraulic lines and connections with suitable
plugs.
• Right rear wheel (1)
• Master cylinder front (2)
• Right front wheel (3)
• Left front wheel (4)
• Left rear wheel (5)
• Master cylinder rear (6)
3. Disconnect the hydraulic controller unit harness
connector (1) from the CAB.
4. Remove the HCU upwards, by carefully pushing
the hydraulic lines to one side and carefully pull up.
ZH