Installation; Pilot Bearing; Removal - Chrysler 2005 Crossfire SRT6 Service Manual

6 - 22 CLUTCH

INSTALLATION

Note: If a new flywheel is installed, perform the
First Initialization Reset function in the Powertrain
Control Module with the DRB III . Refer to the
Reset Adaptives menu selection on the DRB III .
Note: Align flywheel on straight pin in crankshaft.
Note: New bolts must always be used when
installing the flywheel.
1. Position the flywheel (3) on the crankshaft.
2. Install the spacer (2) and new flywheel bolts (1).
3. Install Special Tool 9102 (1) Flywheel Locking Tool.
4. Initially tighten the flywheel bolts to 45 N·m (33 ft.
lbs.). For final torque, rotate the flywheel bolts an
additional 45° clockwise using a torque angle
gauge.
5. Install the clutch (Refer to 6 - CLUTCH/CLUTCH
DISC - INSTALLATION).
6. Remove Special Tool 9102 Flywheel Locking Tool.
7. Install the transmission (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/MANUAL - INSTALLATION).

PILOT BEARING

REMOVAL

1. Remove the transmission (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - REMOVAL).
2. Remove the clutch cover and clutch disc (Refer to 6 - CLUTCH/PRESSURE PLATE - REMOVAL).
3. Remove the pilot bearing with an internal (blind hole) puller.
INSTALLATION
1. Lubricate new bearing with Mopar high temperature bearing grease or equivalent.
2. Start new bearing into crankshaft by hand, then seat bearing with clutch alignment tool.
3. Lightly scuff sand flywheel surface with 180 grit emery cloth. Then clean surface with wax and grease remover.
4. Install clutch disc and clutch cover (Refer to 6 - CLUTCH/CLUTCH DISC - INSTALLATION).
5. Install the transmission (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - INSTALLATION).
ZH