Installation - Srt - Chrysler 2005 Crossfire SRT6 Service Manual

ZH
4. Connect the coolant level sensor harness connec-
tor (2).
5. Connect the small coolant hose (4) from the radia-
tor to the top of the coolant recovery reservoir.
6. Connect the large coolant hose (3) to the bottom of
the coolant recovery reservoir.
7. Refill the cooling system. (Refer to 7 - COOLING/
ENGINE/COOLANT - STANDARD PROCEDURE).
8. Connect the negative battery cable.
9. Start the engine and check for coolant leaks.
10. Recheck the coolant level.

INSTALLATION - SRT

1. Position the coolant recovery reservoir in the
engine compartment.
2. Install the two retaining nuts (2). Tighten the nuts to
5 N·m (44 in. lbs.).
3. Connect the coolant overflow hose (1).
ENGINE 7 - 31