Replacing The Irmc Microsd Card; Preliminary Steps; Concluding Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

System board and components

15.4.3 Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers

15.4.3.1 Preliminary steps

"Locating the defective server" on page 45
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the power cord" on page 49
Ê
"Getting access to the component" on page 50
Ê
15.4.3.2 Replacing the iRMC microSD card
Ê Remove the defective iRMC microSD card, see section
iRMC microSD card" on page
V
CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new iRMC microSD card, see section
microSD card" on page

15.4.3.3 Concluding steps

"Reassembling" on page 55
Ê
"Connecting the power cord" on page 59
Ê
"Switching on the server" on page 60
Ê
364
362.
361.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Removing the
"Installing the iRMC
RX2520 M4