Honda CBF600SA Service Manual page 475

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
HYDRAULIC BRAKE
Remove the pad spring, collar and caliper sub slide
BOOT
COLLAR
pin boot from the caliper body.
If the boot is hard, deteriorated or deteriorated,
replace it with a new one.
PAD SPRING
CALIPER BODY
Place a shop towel over the piston.
Position the caliper body with the piston facing
Do not use high
down and apply small squirts of air pressure to the
pressure air or bring
fluid inlet to remove the piston.
the nozzle too close
to the inlet.
Push the dust seal and piston seal in and lift them
Be careful not to
PISTON SEAL
out.
damage the piston
sliding surface.
Clean the seal grooves with clean brake fluid.
DUST SEAL
INSPECTION
Check the caliper cylinder and piston for scoring or
other damage.
Measure the each caliper cylinder I.D.
SERVICE LIMIT: 38.24 mm (1.506 in)
Measure the each caliper piston O.D.
SERVICE LIMIT: 38.09 mm (1.500 in)
15-39
email: info@motomatrix.co.uk