Drive Chain Slider - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
Make sure that the master link pins are installed
properly.
Measure the master link pin length projected from
the plate.
STANDARD LENGTH:
1.3 – 1.5 mm (0.05 – 0.06 in)
Stake the master link pins.
Make sure that the pins are staked properly by mea-
suring the diameter of the staked area using a slide
caliper.
DIAMETER OF THE STAKED AREA:
5.50 – 5.80 mm (0.217 – 0.228 in)
After staking, check the staked area of the master
A drive chain with a
link for cracks.
clip-type master link
If there is any cracking, replace the master link, O-
must not be used.
rings and plate.

DRIVE CHAIN SLIDER

Remove the crankcase rear cover (page 7-4).
Inspect the drive chain slider for excessive wear or
damage.
If it is worn to the wear indicator, replace the drive
chain slider (page 14-20).
email: info@motomatrix.co.uk
MAINTENANCE
MASTER LINK PINS
SLIDE CALIPER
GOOD NO GOOD
CRACKED
WEAR INDICATOR
3-23