Honda CBF600SA Service Manual page 410

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
FRONT WHEEL/SUSPENSION/STEERING
Install the clamp.
Connect the ignition switch 2P (Brown) connector
and immobilizer 4P connector.
Install the combination meter rubber.
CBF600S/SA only:
Install the following:
– front wheel (page 13-20)
– handlebar (page 13-11)
– headlight case (CBF600N/NA) (page 20-7)
– front center cowl (CBF600S/SA) (page 2-10)
STEERING HEAD BEARING PRE-LOAD
Jack-up the motorcycle to raise the front wheel off
the ground.
Position the steering stem to the straight ahead
position.
Hook a spring scale to the fork tube and measure
Make sure that
the steering head bearing pre-load.
there is no cable or
wire harness
The pre-load should be within 8.8 – 13.7 N (0.9 – 1.4
interference.
kgf, 2.0 – 3.1 lbf).
If the readings do not fall within the limits, lower the
front wheel to the ground and adjust the steering
bearing adjusting nut.
13-42
email: info@motomatrix.co.uk
CBF600S/SA shown:
2P (Brown) CONNECTOR
CLAMP
4P CONNECTOR
RUBBER
90°