Honda CBF600SA Service Manual page 426

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
REAR WHEEL/SUSPENSION
SHOCK ABSORBER DISPOSAL
PROCEDURE
Center punch the damper case to mark the drilling
point.
Wrap the shock absorber inside a plastic bag.
Support the shock absorber upright in a vise as
shown.
Through the open end of the bag, insert a drill
motor with a sharp 2 - 3 mm (5/64 - 1/8 in) drill bit.
Point the valve
Hold the bag around the drill motor and briefly run
away from you to
the drill motor inside the bag; this will inflate the
prevent debris
bag with air from the motor and help keep the bag
getting in your
from getting caught in the bit when you start.
eyes.
NEEDLE BEARING REPLACEMENT
Remove the pivot collar and dust seals.
Press out the needle bearing out of the shock
absorber lower mount using the special tools.
TOOLS:
Driver shaft
Attachment, 22 X 24 mm
14-16
email: info@motomatrix.co.uk
PIVOT COLLAR
DRIVER SHAFT
07946-MJ00100
07746-0010800
NEEDLE BEARING
35 mm
(1.4 in)
SHOCK ABSORBER
DUST SEALS
ATTACHMENT