Drive Chain - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
MAINTENANCE

DRIVE CHAIN

DRIVE CHAIN SLACK INSPECTION
Turn the ignition switch OFF, place the motorcycle
Never inspect and
on its sidestand and shift the transmission into neu-
adjust the drive
tral.
chain while the
engine is running.
Check the slack in the drive chain lower run midway
between the sprockets.
CHAIN SLACK: 20 – 30 mm (1.0 – 1.2 in)
Excessive chain slack, 50 mm (2.0 in) or more, may
damage the frame.
Lubricate the drive chain with #80 – 90 gear oil or
chain lubricant designed specifically for use with O-
20 – 30 mm (1.0 – 1.2 in)
ring chains. Wipe off the excess oil or chain lubri-
cant.
ADJUSTMENT
Loosen the rear axle nut and adjuster lock nuts.
INDEX MARK REAR AXLE NUT
Turn both adjusting nuts until the correct drive
chain slack is obtained.
Make sure the index marks on the both axle wash-
ers aligned with the index marks of the swingarm.
Tighten the both drive chain adjuster lock nuts to
the specified torque.
TORQUE: 21 N·m (2.1 kgf·m, 15 lbf·ft)
Tighten the rear axle nuts to the specified torque.
TORQUE: 98 N·m (10.0 kgf·m, 72 lbf·ft)
ADJUSTING NUT
LOCK NUT
Recheck the drive chain slack and free wheel rota-
tion.
Lubricate the drive chain with #80 – 90 gear oil or
drive chain lubricant designed specifically for use
with O-ring chains. Wipe off the excess oil or chain
lubricant.
Check the drive chain wear indicator label attached
on the left drive chain adjusting plate.
If the swingarm index mark reaches red zone of the
indicator label, replace the drive chain with a new
one (page 3-21).
RED ZONE
3-19
email: info@motomatrix.co.uk