Honda CBF600SA Service Manual page 490

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
ANTI–LOCK BRAKE SYSTEM (ABS; CBF600SA/NA)
PROBLEM CODE INDICATION PATTERN
• The ABS indicator indicates the problem code by blinking a specified number of times.
The indicator has two types of blinks, a long blink and short blink. The long blink lasts for 1.3 sec-
onds, the short blink lasts for 0.3 seconds. When two long blinks occur, and three short blinks, that
problem code is 23 (two long blinks = 20 blinks, three short blinks = 3 blinks). Then, go to the trouble-
shooting and see problem code 23.
• When the ABS control unit stores some problem codes, the ABS indicator shows the problem codes
in the order from the lowest number to highest number. For example, when the indicator indicates
code 12, then indicates code 23, two failures have occurred.
When the problem code is not stored:
PROBLEM CODE READOUT
• The problem code is not erased by turning the
ignition switch to "OFF" while the problem code
is being output. Note that turning the ignition
switch to "ON" again does not indicate the prob-
lem code. To show the problem code again,
repeat the problem code retrieval procedures
from the beginning.
• After diagnostic troubleshooting, erase the prob-
lem code(s) and perform the pre-start self-diag-
nosis to be sure that there is no problem in the
ABS indicator (indicator is operating normally).
1. Remove the side cover (page 2-5).
Remove the dummy connector from the ABS ser-
vice check 3P (Natural) connector.
Short the wire terminals of the service check con-
nector with a jumper wire with the ignition
switch turned to "OFF".
CONNECTION: Brown/white – Green
16-8
email: info@motomatrix.co.uk
3P (Natural)
CONNECTOR
Brown/white
JUMPER WIRE
Green