Honda CBF600SA Service Manual page 127

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
HDS POCKET TESTER INFORMATION
• The HDS can readout the DTC, freeze data, current data and other ECM condition.
How to connect the HDS Pocket Tester
Turn the ignition switch to OFF.
Lift and support the fuel tank (page 3-5).
Remove the dummy connector from the DLC.
Connect the HDS pocket tester to the DLC.
Turn the ignition switch ON and engine stop switch "
DTC and freeze data.
• Freeze data indicates the engine conditions when the first malfunc-
tion was detected.
ECM reset
The HDS can reset the ECM data including the DTC, freeze data and
some learning memory.
DTC READOUT
Start the engine and check the MIL.
• If the engine will not start, turn the starter motor for more than 10
seconds and check that the MIL blinks.
• When the ignition switch is turned ON, the MIL will stay on for a few
seconds, then go off.
If the MIL stays on or blinks, connect the HDS Pocket Tester to the DLC
(page 5-13).
Read the DTC, freeze data and follow the troubleshooting index (page
5-16).
To read the DTC with the MIL blinking, refer to the following proce-
dure.
Reading DTC with the MIL
Turn the ignition switch to OFF.
Lift and support the fuel tank (page 3-5).
Remove the dummy connector and short DLC terminals using the spe-
cial tool.
TOOL:
SCS connector
CONNECTION: Brown – Green
Turn the ignition switch ON and engine stop switch "
the MIL blinks and refer to the troubleshooting index (page 5-16).
If the ECM has any DTC in its memory, the MIL will start blinking.
email: info@motomatrix.co.uk
070PZ-ZY30100
DUMMY CONNECTOR
", check the
S/SA model:
MIL
SCS CONNECTOR
", read, note
FUEL SYSTEM (PGM-FI)
DLC
N/NA model:
DLC
5-13