Honda CBF600SA Service Manual page 469

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
Coat new piston seals with clean brake fluid and
install them into the seal grooves in the caliper.
Coat new dust seals with silicone grease and install
them into the seal grooves in the caliper.
Coat the caliper pistons with clean brake fluid and
Install the shorter
install them into the caliper cylinders with the open-
piston into the
ing toward the pads.
center cylinder.
Install the brake pad retainer and caliper pin boot
into the caliper bracket.
Install the bracket pin boot into the caliper body.
Install the pad spring in the caliper body.
Note the installation
direction of the pad
Apply silicone grease to the caliper and bracket pins
spring.
and install the caliper bracket over the caliper body.
INSTALLATION
Install the brake caliper onto the fork leg.
Install and tighten the new brake caliper mounting
bolts to the specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Install the front wheel speed sensor (page 16-24).
Install the brake hose eyelet to the caliper body with
two new sealing washers and oil bolt.
Push the brake hose eyelet to the stopper on the cal-
iper body, then tighten the oil bolt to the specified
torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the front brake pads (page 15-15).
Fill and bleed the front brake hydraulic system
(page 15-8).
email: info@motomatrix.co.uk
HYDRAULIC BRAKE
PISTON SEALS
DUST SEALS
CALIPER BODY
BOOT
BOOT
PAD SPRING
BRAKE CALIPER
OIL BOLT
CALIPER
PISTONS
CALIPER BRACKET
PAD
RETAINER
BOLTS
SEALING
WASHER
15-33