Honda CBF600SA Service Manual page 546

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
ELECTRIC STARTER
STARTER RELAY VOLTAGE
INSPECTION
Connect the starter relay switch 4P connector.
Shift the transmission into neutral.
Measure the voltage between the Yellow/red wire
terminal (+) and ground (–).
If the battery voltage appears only when the starter
switch is pushed with the ignition switch ON and
engine stop switch "
CONTINUITY INSPECTION
Disconnect the 4P connector, battery(+) cable and
starter motor cable from the starter relay switch.
Connect a fully charged 12 V battery positive wire to
the relay switch Yellow/red wire terminal and nega-
tive wire to the Green/red wire terminal.
Connect an ohmmeter to the starter relay switch
large terminals.
There should be continuity between the large termi-
nals when the battery is connected, and no continu-
ity when the battery is disconnected.
REMOVAL/INSTALLATION
Remove the right side cover (page 2-5).
Disconnect the starter relay switch 4P connector.
Remove the bolts and disconnect the starter relay
cables.
Remove the starter relay switch from the stay.
Installation is in the reverse order of removal.
19-16
email: info@motomatrix.co.uk
", it is normal.
4P CONNECTOR
Green/red
TERMINAL
CABLES
STARTER RELAYSWITCH
STAY
Yellow/red
TERMINAL
4P CONNECTOR
BOLTS