Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
CRANKSHAFT/PISTON/CYLINDER
CRANKPIN BEARING
Do not interchange the bearing inserts. They must
be installed in their original locations or the correct
bearing oil clearance may not be obtained, resulting
in engine damage.
Remove the crankshaft (page 12-5).
BEARING INSPECTION
Check the bearing inserts for unusual wear or peel-
ing.
BEARINGS
Check the bearing tabs for damage.
TABS
OIL CLEARANCE INSPECTION
Clean off any oil from the bearing inserts and crank-
PLASTIGAUGE
pins.
Carefully install the crankshaft onto the upper crank-
case.
Set the connecting rods onto the crankpins.
Put a strip of plastigauge lengthwise on each
crankpin avoiding the oil hole.
• Do not rotate the crankshaft during inspection.
Carefully install the connecting rod bearing caps by
aligning the I.D. code.
Apply engine oil to the connecting rod bearing cap
nut threads and seating surfaces, and install them.
BEARING CAP NUTS
12-11
email: info@motomatrix.co.uk