Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
HYDRAULIC BRAKE
Install the brake hose eyelet to the caliper body with
two new sealing washers and oil bolt.
Push the brake hose eyelet to the stopper on the cal-
iper body, then tighten the oil bolt to the specified
torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the front brake pads (page 15-15).
Fill and bleed the front brake hydraulic system
(page 15-7).
REAR BRAKE CALIPER (CBF600SA/NA)
REMOVAL
Drain the rear brake hydraulic system (page 15-7).
Remove the rear brake pads (page 15-17).
Remove the oil bolt, sealing washers and brake
Avoid spilling fluid
hose eyelet joint.
on painted, plastic,
or rubber parts.
Place a rag over
these parts
whenever the
system is serviced.
Pivot the caliper up and remove it.
DISASSEMBLY
Remove the pad retainer and caliper main slide pin
boot from the caliper bracket.
If the caliper main slide pin boot is hard or deterio-
rated, replace it with a new one.
15-38
email: info@motomatrix.co.uk
OIL BOLT
SEALING WASHERS
SEALING WASHERS
BRAKE CALIPER
PAD RETAINER
OIL BOLT
BOOT