Table of Contents
Advertisement
CHAN - FDR Bus Page
Joker Button*:
5.6
Signaling
Date printed: 18.07.08
TB Status
Off
On
Programming TB group
Cut
-
-
Ready Status
Off
On
*
On the CHAN - FDR Bus page, the Joker button never indicates the PFL
status since the page contains a dedicated PFL button.
The OnAir 2500 has full-way red light signaling, which means that the audio
path must be open from the microphone to the master output in order that
red light indication becomes active. Signaling settings are performed in the
configuration tool.
Signaling is provided for control room and studio; it works with the config-
ured behavior of the inputs describing the microphone locations. Red light
indication in the control room is provided in the monitoring/TB part of the
central module and in the central screen. Possible locations are CR (control
room) and ST (studio).
The ON AIR indication may be AND-linked with an external signal, e.g. com-
ing from the master control room, indicating that the signal is actually routed
to the antenna (see GPIO section). It is configurable which main master (or
which combination of them) activates the ON AIR indication.
Example
Red light indication for a particular location is active if:
• at least one microphone input in this location is routed to a channel,
AND
• this channel's fader is open, the channel is switched ON and is routed to a
main master,
AND
• this main master's fader (if configured) is open.
SW V3.0
OnAir 2500 Digital Mixing Console
Joker Button Function
TALK or PFL/TALK
Joker Button Function
PFL/LOC
Joker Button Function
LOC/RDY
Joker Button Indication
Dark
Yellow
Yellow if assigned to group
Yellow
Joker Button Indication
Always dark
Joker Button Indication
Dark
Yellow
Operation 5-53
Advertisement
Table of Contents
