Timer Operation; Manual Operation; Automatic Operation - Studer OnAir 500 Operating Instructions Manual

9

TIMER OPERATION

9.1

Manual Operation

Button Actions:
9.2

Automatic Operation

Date printed: 30.07.04
The OnAir 500 contains two timers. These can be controlled either directly
from the buttons on the meter bridge, or automatically from the channel fad-
ers.
The TIMER 2 button indicates which timer the START, STOP, and RESET but-
tons will operate.
If the TIMER 2 button is illuminated, then the START, STOP, and RESET but-
tons control TIMER 2 (the red display on the right). If the TIMER 2 button is
not illuminated, the START, STOP, and RESET buttons control TIMER 1 (the
green, left-hand display).
If the timer is running, the START button will be illuminated; otherwise the
STOP button will be illuminated.
• Pressing the STOP button will stop the active timer.
• Pressing the START button will start the currently active button.
• Pressing the RESET button will reset the currently active timer, but will
not alter its stopped/running state.
• Pressing the TIMER 2 button will change the currently active timer from 1
to 2 or vice versa.
The timers can be controlled automatically by the channel faders (there is a
menu for configuring and enabling the triggering actions).
Press the timer SETUP button located just below the timer displays. The LC
1
display will read:
Channel 1
Not Triggered
Press the SELECT button on the channel you want to configure.
2
OnAir 500 Digital Mixing Console
Tmr1
Timers 9-1